The GRD unit may be retrofitted to either side of a roller door.

Selection of the desired side may be determined by the available room, location of power and general installation.

While the door is supported remove the right hand wall mount bracket.(Fig.

Fig: 5 i) Carefully remove the support from the door and rest spindle on the wall mount bracket j) Locate the Drive unit on the bracket and fit U.

Secure the weight bar with two bolts provided.

Fig 6) Fig: 6 IMPORTANT: Security rivet tek screw must always be applied to inner side of drum wheel as shown in Fig: 7a.

Failure to do so may result in internal damage to the GRD drive unit.

Press and hold ENTER for 2 seconds to enter menu selection 2.

Using UP and DOWN to select Learn option, and press ENTER 3.

Using UP and DOWN, select the desire transmitter key setting from the below options Single Button Configuration: Any one of the three buttons in the transmitter can be used to control all three functions StopOpenClose.

Using UP and DOWN, to adjust the force in the below manner Increase.

Vacation Mode Transmitter signal can be locked out by pressing STOP CLOSE keys simultaneously and holding it for 3 seconds on the transmitter.

Plug the EAS receiver into the EAS receiver sockets properly 4.

Replace control panel cover and LED lens with screws Glidermatic GRD Installation Instructions.

Press buttons 45 simultaneously on the GHI transmitter to code 3.

LED will blink twice to confirm successful programming GHI Transmitter Code Erase 1.

The benefits given to you by our Gliderol Warranty are in addition to other rights and remedies you may have under the Australian Consumer Law.

FOR SALES AND SERVICE, CONTACT GLIDEROL INTERNATIONAL PTY LTD ABN 92 007 928 949 Head Office Gliderol Garage Doors.

Gliderol Door Controller Unit